Majestic L6-3.6L (1989)
drain the reservoir into a 2 quart waste container. Tip the reservoir to fully drain the fluid. Discard all fluid.
B. Reconnect the feed hose. Refit the reservoir to its mounts.
^
Fill the reservoir with new hydraulic fluid and install the reservoir cap.
^
Bleed the ride levelling system using the procedure given at the end of this bulletin.
ALL MODELS - Ride Leveling System Bleeding Procedure
^
Drive the vehicle on a ramp (wheels must support the weight of the vehicle).
^
Apply the parking brake and place the gear selector in P (park).
^
Top-up the power hydraulic fluid reservoir.
^
Start the engine and raise the ramp.
^
Disconnect the ride height sensor link rod at the rear suspension right side lower wishbone.
^
Raise the sensor link rod approximately 1 inch. The rear of the vehicle will rise after approximately 20 seconds.
^
Switch off the engine when the "pulsing" is felt in the strut feed pipe.
^
Remove the bleeder valve cover at the top of the left strut. Connect one end of the hose to the valve and place the other end in a waste container.
^
Open the bleeder valve and allow fluid flow until the suspension lowers fully.
^
Tighten the bleeder valve.
^
Top-up the fluid reservoir.
^
Start the engine and repeat the bleeding operation.
^
Remove the bleed hose and refit the bleeder valve dust cover.
^
Top-up the fluid reservoir.
^
Start the engine
^
Raise the rear suspension by moving the sensor link rod.
^
When "pulsing" is felt in the strut feed pipe, reconnect the sensor link rod to the suspension wishbone. The vehicle will return to normal ride height
after approximately 20 seconds.
^
Lower the ramp and top-up the reservoir.
REPAIR POLICY:
On 1990-92 models with a low pressure hose filter, the filter must be removed care- fully to prevent damage to the hose. The low pressure hose must not
be changed unless it is leaking from the "Y" joint.
PARTS INFORMATION: