Majestic L6-3.6L (1989)
-
Fit a magnetic dial gauge to the output flange and measure the end float (Fig 1).
-
The correct end float should be 0.001 - 0.006in (this end float is pre-set, built into the bearing).
-
If the end float is outside the given tolerances, the output shaft bearing must be replaced.
-
Reconnect the half shaft.
-
Fit and tighten the securing bolts.
-
Refit the road wheel.
-
Fit and tighten the wheel nuts.
-
Remove the stands and lower the vehicle.
SERVICE TOOLS
SL7 Rear hub bearing cone and cup replacer
JD 550-1 Driveshaft oil seal remover/replacer adaptor
18G 134 Driver handle
TORQUE FIGURES
Oil seal housing to gear case ............................................................................................................................................................................ 51 - 58 Nm
Halfshaft to differential output shaft ................................................................................................................................................................ 78 - 95 Nm
TOLERANCES
Output flange end float ............................................................................................................................................................................................. 0.004 in
SPANNER SIZES
17 mm
22 mm
11/16" AF