S-Type (X200) V6-3.0L (2000)
/v6-3.0l/Page-1271009.png)
15.
Using 25 mm diameter hole saw with plain rod as a pilot, cut through roof panel strengthening skin (Illustration 12).
Caution:
On vehicles with a sliding roof, the hole will need to be cut at a slight angle to avoid the sliding roof front mounting. During previous operation
take care not to damage roof outer panel.
From outside of vehicle
Caution:
Throughout the drilling operation be very careful not to distort the outer roof panel.
16.
Open out 3 mm diameter pilot hole in roof outer panel to 10 mm diameter.
17.
Verify marked 14 mm position is still 14 mm from center of drilled 10 mm hole.
18.
Carefully drill 3 mm diameter pilot hole through roof panel at previously marked 14 mm position.
19.
Open out 3 mm pilot hole to 4.8 mm.
From inside vehicle
20.
Using suitable handgrips bend edge of roof intermediate strengthening panel downwards (Illustration 13).
Note:
Bend edge of roof intermediate strengthening panel downwards only sufficient, for aerial base connector access.
From inside and outside vehicle.
21.
Deburr drilled holes/sharp edges.
22.
Remove protective covering from vehicle interior.
