jaguar Workshop Repair Guides

Jaguar Workshop Service and Repair Manuals

Engine - No Start or Misfire & Water in Spark Plug Wells|Page 1385 > < Engine Controls - Driveability Issues/Stalling|Page 1380
Page 1
background image

Spark Plug: Customer Interest
Engine - No Start or Misfire & Water in Spark Plug Wells

S303-12

S-TYPE

DATE 12/02

MODEL 
2000 MY
S-TYPE

VIN 
L00001-L63500

Misfire/Non-Start - Water Ingress Into Spark Plug Wells - Revised On-Plug Coil Cover

Issue:

This Technical Bulletin has been issued due to a number of V8 4.0L vehicles suffering from water entering the spark plug wells, which could cause a
misfire/non-start situation.

A revised stiffer on-plug coil cover was introduced to prevent water ingress.

Action:

In case of a customer complaint of the above condition on a 2000 MY S-TYPE, within the above VIN range, replace the on-plug coil cover if the
complaints are found to be caused by water ingress.

1.

Open hood and fit fender protectors.

2.

Open luggage compartment and displace carpet.

3.

Record the following customer settings before disconnecting the battery so they can be reset to the customer's preferred setting:

^

Clock 12/24 hr setting

^

CD compress mode (if equipped)

^

Navigation volume defaults to 14 (if equipped)

^

Voice feedback volume defaults to 14 (if equipped)

^

Transmission mode (sport/normal)

^

Radio presets - AM/FM, Bass, Treble settings

^

Compass calibrations and zone setting

Navigation memory will be retained if the battery is not disconnected longer than 24 hours.

4.

Remove air cleaner outlet pipe (see Workshop Manual, JTIS CD ROM, section: 303-12B, SRO 19.10.31).

5.

If fitted, remove the Evaporative (EVAP) Emission Canister Purge Valve (see Workshop Manual, JTIS CD ROM, section: 303-13, SRO
17.15.30).

6.

Remove the oil level indicator.

Engine - No Start or Misfire & Water in Spark Plug Wells|Page 1385 > < Engine Controls - Driveability Issues/Stalling|Page 1380