S-Type (X200) V6-3.0L (2000)
/v6-3.0l/Page-672003.png)
18.
Where previously cut to enable removal of the fuel delivery module, install, but do not fully tighten, a new tie strap.
Note:
Ensure that the locking device is located against the clamp on the filter body If the tie strap is fully-tightened at this stage, it will be impossible
to reinstall the fuel delivery module into the tank.
19.
Position the fuel delivery module in the fuel tank and fully seat the module.
20.
Fully tighten the tie-strap, to hold the filter assembly tightly against the pump body, with no slack in the tie-strap.
21.
Install a new gasket, then position and tighten the retaining ring, using special tool J310-169 to a torque of 60-70 Nm.
22.
Reconnect the fuel hoses to the fuel delivery module. Check their security of each connector, without depressing the lock buttons, by pulling along
the centerline of each hose, exerting a pull of 40 N (10 lbs.) away from the connector.
23.
Reconnect the multiplug.
24.
If the tank was previously drained, refill the tank.
25.
Reconnect the battery Start the engine. Check that no fuel leaks exist.
26.
Clear away plastic sheeting from within the vehicle. Reinstall the rear seat.
27.
Reset the clock and reset the compass.
28.
When possible, park the vehicle with all windows open to allow any residual fuel odors to dissipate, before returning the vehicle to the customer.
If parked in the open air, remove the keys and store in a secure location.
Parts Information
Warranty Information
NOTE:
Always perform a DCS claim search first to determine whether this service action has been performed on this vehicle. The warranty selection under
the vehicle inquiry will give a listing of all claims against the vehicle. If S144 appears in the fault code field, do not perform this service action.
CLAIM SUBMISSION PROCEDURE:
Warranty summary codes have been assigned to this service action in order to simplify claim submission. The dealership will be reimbursed the parts and
labor time allowance as indicated.
DCS DEALERS
