S-Type (X200) V6-3.0L (2000)
32.
* Remove *and discard* the manual control lever *and* the park pawl actuating rod (Illustration 9).*
33.
* Install the new manual control lever *and new* park pawl actuating rod (Illustration 10).*
34.
Connect the manual control lever to manual control lever shaft and engage on flats.
35.
Install but do not tighten the manual control lever securing nut.
36.
Reposition manual control lever shaft into main case.
37.
Rotate the manual control shaft until the internal lever rear stop contacts main case.
Caution:
During the following operation, be careful not to bend the manual control valve operating peg.