S-Type (X200) V6-3.0L (2000)
Seals and Gaskets: Service and Repair
Seal - Output Shaft
Removal
1. Raise and support the vehicle.
2. Remove the intermediate muffler.
3. Remove the center heat shield.
4. CAUTION: Under no circumstances must the flexible coupling (or its fixings) be loosened or removed from the driveshaft
Detach the transmission flexible joint.
Mark the position of the driveshaft in relation to the transmission flange.
Mark the position of each nut and bolt in relation to the transmission flexible joint.
5. NOTE: Support the front section of the driveshaft.