S-Type (X200) V8-4.0L (AJ28) (2001)
Cellular Phone: Description and Operation
The portable cellular phone system consists of:
-
Cellular phone handset.
-
Handset battery.
-
Handset presenter.
-
Coil cord.
-
Steering column shroud mounted microphone.
-
Steering wheel switch controls.
-
Portable support electronics (PSE) module.
-
In-glass cellular phone antenna.
-
Antenna cable.
-
Audio unit controls.
On vehicles with satellite navigation, the cellular phone handset presenter is located within the center console stowage compartment. The audio control
unit and the steering wheel controls are utilized to operate the system.
On vehicles without satellite navigation, the cellular phone handset presenter is located within the center control panel. The presenter consists of:
-
A horizontal sliding device.
-
A pivoted phone holder.
The S-Type utilizes two unique cellular phones systems:
-
GSM
-
AMPS
The voice activation control module provides the handsfree operation for cellular phone.
To activate the handsfree function:
1. Switch the ignition to the RUN position. After 4-6 seconds the system will be initialized and "VOICE READY" will be displayed in the message
center.
2. Operate the VOICE/PHONE switch on the steering wheel.
3. Clearly state the command when "LISTENING" is displayed in the message center.
4. Operate the VOICE/PHONE switch on the steering wheel or remain silent for 1 second. If speech is detected "PROCESSING" will be displayed
in the message center. Operating the VOICE/PHONE switch again will cancel the voice session.
Refer to the Cellular Phone user guide for complete operating instructions.
For additional information on the voice activation control module See: Voice Activation System