S-Type (X200) V8-4.0L (AJ28) (2001)
General Module: Service and Repair
Module - Driver Door (DDM)
Removal
1. CAUTION: Prior to removal of the module, it is necessary to upload module configuration information to the PDU. This information needs to be
downloaded into the new module once installed.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
Disconnect the battery ground cable.
2. Remove the driver side door trim panel.
3. Detach the driver door module (DDM).
4. Remove the DDM.
Installation
1. To install, reverse the removal procedure.