S-Type (X200) V8-4.0L (AJ28) (2001)
/v8-4.0l_(aj28)/Page-1498003.png)
Installation
1. NOTE: The control module wax timing pin is still in place.
Make sure the shoulder of each cable sleeve is correctly seated in the roof opening panel control module.
2. Fully tighten the control module screw.
3. CAUTION: Do not overtighten the roof opening panel motor screws. Damage to the roof opening panel control module may result.
Install the roof opening panel motor screws.
4. Remove the control module wax timing pin.
5. Install the electrical harness cable tie.
6. Reconnect the roof opening panel control module electrical connectors.
