S-Type (X200) V8-4.0L (AJ28) (2001)
/v8-4.0l_(aj28)/Page-986002.png)
6. Remove the brake pads.
Installation
CAUTION:
-
If the pistons are pushed back into the housing, brake fluid will be forced back into the fluid reservoir.
-
Make sure that the brake disc faces are clean before installation.
NOTE: Make sure the piston location mark is in the correct position so that the locator pin on the pad backplate locates correctly into the piston.
1. To install, reverse the removal procedure.
-
Using the Snap On tool KS326, fully retract the brake caliper piston.
-
Install new caliper guide pin retaining bolts.
