S-Type (X200) V8-4.0L (AJ28) (2001)
crankshaft pulley.
10. Remove the thrust button from the end of the crankshaft.
11. Remove the crankshaft pulley remover and adapter from the crankshaft pulley.
12. Remove the split locking ring.
Installation
1. NOTE: Apply a suitable amount of clean engine oil to lubricate the crankshaft pulley bore and the crankshaft front oil seal.
Install, but do not tighten, a new crankshaft pulley retaining bolt.
1. Install the crankshaft pulley.
2. Install the split locking ring.
3. Install, but do not tighten, a new crankshaft pulley retaining bolt.
2. CAUTION: Under no circumstances should the crankshaft setting peg 303-645 be used in the following operations to lock the crankshaft.