S-Type (X200) V8-4.0L (AJ28) (2001)
/v8-4.0l_(aj28)/Page-1222001.png)
Control Assembly: Service and Repair
Removal and Installation
Removal
1. Remove the centre control stack.
NOTE: When the battery is disconnected and reconnected all previous panel settings and fault codes will be lost. It is necessary to record any
non-standard settings or fault codes before battery disconnection to prevent customer complaint and carry out correct diagnosis.
2. Remove the control assembly screws.
3. Remove the control assembly screws.
4. Remove the control assembly.
