S-Type (X200) V8-4.0L (AJ28) (2001)
Note:
Ensure the cam lobe is fitted centrally between the cam guides on the no. 1 cross-member.
Note:
Fit but do not fully tighten the lock nut, until after the alignment check.
REAR CAM BOLT
Install the bolt from the rear, with the cam lobe down (Illustration 9).
Note:
Ensure the cam lobe is fitted centrally between the cam guides on the no. 2 cross-member.
NOTE:
Fit but do not fully tighten the lock nut, until after the alignment check.
26.
Reposition and align lower wishbone to front damper.
27.
Install and tighten front damper to lower wishbone-securing nut/bolt. Torque setting 175 Nm.
28.
Fit but do not fully tighten new cam bolt securing nuts.
29.
Reposition and align steering rack.
30.
Install and tighten steering rack securing nuts/bolts. Torque setting 103 Nm.
31.
Connect stabilizer link arm to lower wishbone.