S-Type (X200) V8-4.0L (AJ28) (2001)
/v8-4.0l_(aj28)/Page-880009.png)
*Working alone:*
54.
Place a new gasket on the extension housing, install the extension housing on the transmission and install and fully tighten securing bolts.
55.
Raise transmission jack to align the transmission to the correct position.
56.
Install and fully tighten rear mounting securing bolts.
57.
Lower the transmission jack and return transmission jack to the storage area.
58.
Install transmission extension housing seal (see Global Technical Reference GTR Workshop Manual, section: 307-01, SRO 44.20.18).
59.
Connect battery (see Global Technical Reference GTR Workshop Manual, section: 414-01).
*On vehicles from VIN L00600 to M30850 only, continue from step 60, on vehicles from M30851 continue from step 72.*
60.
From under the vehicle, reposition the selector cable outer casing convoluted heat protection away from the crimp.
61.
Visually check to ensure the outer casing has not moved from the crimp. If the cable has moved, replace the selector cable.
62.
Push and pull the outer casing to ensure it does not move within the crimp (Illustration 16). If the cable has moved, replace the selector cable.
63.
Reposition the outer casing convoluted heat protection to original condition.
64.
Reposition the manual control lever so the ball pin is furthest away from the inner cable end.
65.
Remove floor console (see Workshop Manual section: 501-12).
66.
From inside the vehicle, visually check to ensure the selector cable outer casing has not moved from the crimp. If the cable has moved, replace the
selector cable.
67.
Push and pull the outer cable to ensure it does not move within the crimp. If the cable has moved, replace the selector cable.
68.
Raise the gearshift lever locking solenoid plunger to allow operation of the selector lever.
69.
Operate the gearshift lever to check for smooth operation of inner cable, If the cable does not move smoothly, replace the selector cable.
Note:
Leave the selector lever in the N position.
70.
Install floor console (see Workshop Manual section: 501-12).
71.
From underside of vehicle, reposition the manual control lever to the N position.
72.
On all vehicles, connect the inner selector cable to the transmission manual control lever ball pin.
73.
Remove the transmission filler plug.
