S-Type (X200) V8-4.2L (2005)
Air Door Actuator / Motor: Service and Repair
Cold Air Bypass Blend Door Actuator
Cold Air Bypass Blend Door Actuator (82.20.86)
Removal
1. Disconnect the battery ground cable.
2. Remove the driver side instrument panel lower trim panel.
3. Disconnect the cold air bypass blend door actuator electrical connector.
4. Remove the cold air bypass blend door actuator retaining bolts.
5. Remove cold air bypass blend door actuator.
Installation
1. To install, reverse the removal procedure.
NOTE: During installation make sure the actuator is fully meshed with the driven flap before tightening the bolts.