S-Type (X200) V8-4.2L SC (2003)
/v8-4.2l_sc/Page-729004.png)
Note:
Jack under the center of the rear drive axle/differential to install the left-side rear bushing lower void insert. Jack under the right-hand side lug
to install the right-side rear bushing lower void insert (Illustration 5).
Caution:
Do not use any other lubricant as this can cause damage to the rubber bushing material.
11.
Lubricate the lower void of left bushing with a suitable tire lubricant. If this is not available, use water.
12.
Position insert into lower void of left bushing.
13.
Using a suitable tool, force insert part way into lower void of left bushing.
14.
Using a suitable lever positioned against the front face of the spare wheel well protection, lever insert fully into position.
15.
Lower jack.
16.
Remove protective material, and transfer to the front face of the spare wheel well behind the right-side bushing.
17.
Carry out steps 3 to 15 to install inserts into the voids of the right-side differential bushing.
18.
Remove block of wood from jack and place aside.
19.
Remove jacking device.
20.
Remove adhesive tape and protective material.
21.
Lower vehicle on lift.
Parts Information:
Warranty Information:
