Sovereign L6-4.0L (1991)
Wheel Bearing: Service and Repair
HUB BEARING
-
Slacken off the front road wheel nuts 1/4 turn each.
-
Jack up the front of the vehicle and support with axle stands.
-
Remove one wheel nut, mark the wheel relative to the stud, and remove the remaining wheel nuts.
-
Remove the road wheel/tire assembly.
-
Disconnect the brake pad wear sensor block connector.
-
Remove the lower guide pin bolt (1) from the caliper.
-
Pivot the caliper (1) upwards to gain access to the brake pads (2).
NOTE:Use an open-ended spanner to hold the guide pin during removal. This will prevent damage to the rubber dust cover.
-
Remove the brake pads and remove the upper guide pin bolt.