Sovereign L6-4.0L (1991)
-
Disconnect the brake pad wear sensor block connector.
-
Remove the lower guide pin bolt (1) from the caliper.
-
Pivot the caliper (1) upwards to gain access to the brake pads (2).
NOTE:Use an open-ended spanner to hold the guide pin during removal. This will prevent damage to the rubber dust cover.
-
Remove the brake pads and remove the upper guide pin bolt.
-
Re-position the caliper for access to the carrier securing bolts (3), cut and remove the lock wire (4).
-
Remove the carrier securing bolts and remove the carrier.
-
Remove the disc securing screw and remove the disc.
-
Pry off the hub grease cap.