Vanden Plas L6-3.6L (1988)
1.
Remove the wood veneer finisher and door top roll.
2.
Remove the door lower casing and disconnect all harnesses.
3.
Remove the door armrest and remove the securing bracket holding the switch pack into the armrest.
4.
Where necessary disconnect the puddle lamp harness to allow improved access to the switch pack.
5.
Fit anti-rattle clips BD 10313 to switch pack webs at the locations indicated in the illustration.
6.
To reassemble, reverse the removal procedure.
7.
Finally road test the vehicle for rattles.
Repair Operation Number and Time:
76.91.26 0.65 hours
Fault Codes:
8AZR RF Door
8GZR
RR Door
8KZR
LR Door
CAUTION: Part Numbers included in Service Bulletins are for reference only and should always be cross referenced with the latest parts information.
Technical Service Bulletin # 7617
Date: 880101
Window Switch Packs - Rattle
BODY RATTLES
SECTION:
76
No:
17
Model:
XJ6 3.6 Date: JANUARY, 1988
KEY POINTS:
INTRODUCTION OF ANTI-RATTLE
CLIPS. WINDOW SWITCH PACKS
Excessive sideways displacement of the switch pack within the armrest assembly of the passenger doors can produce rattles. To correct this fault,
anti-rattle clips have been introduced on all models from VIN 525264. To correct vehicles prior to this VIN the following procedure should be carried
out.
1.
Remove the wood veneer finisher and door top roll.
2.
Remove the door lower casing and disconnect all harnesses.
3.
Remove the door armrest and remove the securing bracket holding the switch pack into the armrest.
4.
Where necessary disconnect the puddle lamp harness to allow improved access to the switch pack.
