Vanden Plas L6-4.0L (1990)
Rear Door Window Glass: Service and Repair
RENEW
- Open the door.
- Remove the rear door trim pad veneer panel. See: Front Door/Front Door Panel/Service and Repair
- Remove the rear door upper trim pad.
- Remove the rear door lower trim pad.
- Remove the door aperture plastic closing panels.
- Fit adhesive tape (1, Fig. 2) over the door frame to secure the glass.
- Remove the screws and nuts (2, Fig. 2) securing the window lift motor to the door glass.
- Remove the screws (1, Fig 2) securing the window lift guide to the door and carefully displace the mechanism from the door glass and position in the
bottom of the door.
- Remove the grommet to gain access to the rear frame upper securing screws and remove the screws securing the glass frame to the door.
- Lift the glass and frame assembly from the door, remove the adhesive tape securing the glass to the door frame and remove the glass.
- Fitting is the reversal of this procedure.
