Vanden Plas L6-4.0L (1990)
NOTE:
Fig. 1 shows an XJS front hub and Fig. 2 shows a Sedan front hub. All procedures apply to both models.
^
If the reading is within 0.001" - 0.003", no adjustment is necessary.
^
If adjustment is necessary, remove the cotter pin and nut cover, (Fig. 1 B & C).
^
Adjust end float as necessary to give a reading of 0.001" - 0.003".
^
Align the hub nut cover and secure with a new cotter pin.
^
Check the front hub end float again.
^
Install the grease cap.
^
Perform the above procedure on the opposite front hub.
^
Install the road wheels. Make sure that the wheel nuts are tightened to 65-75 ft.lbs.
^
Before moving the vehicle, pump the brake pedal to re-set the brake pads. Remove cloth from around brake fluid reservoir cap.
