Vanden Plas L6-4.0L (1990)
Ignition Rotor: Technical Service Bulletins
Tool - JD189 Distributor Body/Rotor Arm Set Position
18-25
Distributor Body/Rotor Ann - Set Position
Using Service Tool JD 189
MODEL:
88 MY-onwards AJ6 Engine
DATE:
10/92
SUPERSEDES:
TECHNICAL BULLETIN 86-64
ISSUE:
Service Tool JD 189 has been introduced for checking and setting the distributor body and rotor arm position on AJ6 engines.
ACTION:
To check and/or set the distributor body and rotor arm position, use the following procedure:
^
Un-clip and remove the distributor cap (H.T. leads connected).
^
On the compression stroke of the No. 1 cylinder, set the engine to T.D.C. by aligning the leading edge of the marked tooth on the crankshaft
reluctor wheel with the pointer on the timing cover, (Fig. 1).
^
Fit tool JD 189 to the distributor body, (Fig. 2). Make sure that the lug on the tool engages with the notch in the distributor body.
^
If necessary, loosen the distributor clamp bolt and rotate the distributor body until the tool engages with the notch. Then tighten the distributor
clamp bolt.
^
Remove the tool and install the distributor cap.
WARRANTY INFORMATION:
Fault Code
R.O. Number/Desc.
Time Allowance
