Vanden Plas L6-4.0L (1990)
4.
Remove the four rear cover retaining screws. One screw is located on each side of the control panel assembly, two screws are located at the top of
the assembly (Illustration 2).
5.
Install the two nylon screws from the kit JLM 11238 as shown in Illustration 3.
CAUTION:
Do not over tighten the nylon screws.
6.
Refit the rear cover panel using the original screws.
7.
Reassemble and install the center console facia assembly.
8.
Connect the battery ground cable and code the radio and security system.
9.
Reset the clock and program the preset radio stations.
10.
Verify climate control, radio and security system operation.
AIR CONDITIONING MICROSWITCH REPLACEMENT PROCEDURE
1.
Record all customer preset radio stations (including X-Mem) and disconnect the battery ground cable.
NOTE:
Make sure the radio security code and all security system transmitters are available:
2.
Remove the center console fascia panel assembly.
