Vanden Plas L6-4.0L (1990)
Throttle Cable/Linkage: Service and Repair
Throttle Pedal
1.
Remove cotter pin from pedal end of cable.
Throttle Cable
2.
On engine, remove linkage retaining clip and disconnect cable end from linkage.
3.
Remove cable from body grommet and remove grommet from body.
4.
Remove cable assembly.
5.
Fit new cable to vehicle. Be sure grommet is fully seated into body panel.
6.
Seat cable into grommet.
7.
Fit cable end to throttle pedal.
8.
Fit clevis pin and cotter pin.
9.
On engine, fit cable end to linkage piece and secure with clip.
10.
Fit cable housing to mounting bracket.
