Vanden Plas L6-4.0L (1990)
FIG. 8
^
Hold the pump and loosen the center bolt to release the pump, (fig. 8). Lift out tbe drive dog.
Replacement Procedure:
FIG. 9
^
Position the plate part of JD 119 in a vice, (fig. 9).
Note:
This procedure uses the opposite end of the plate to that in the removal procedure.
FIG. 10
^
Place the drive dog on the pump's shaft (dogs facing upwards). Assemble tool 18G 1445 as indicated in figure 10 (the hexagon should be above
the center section). Screw the bolt into the pump's shaft until fully engaged and finger tight.
FIG. 11
