Vanden Plas L6-4.2L (1982)
Wheel Hub: Service and Repair
Rear Suspension
REAR HUB AND CARRIER ASSEMBLY
Remove and refit
Service tools: Hub puller JD 1D. Dummy shaft JD 14.
Removing
-
Remove rear road wheel.
-
Place stand under rear of car.
-
Remove fulcrum shaft grease nipple (1) from hub carrier.
-
Withdraw split pin. remove castellated nut and plain washer (2) from splined end of haft-shaft and fit thread protector over end of shaft.
-
Fit hub puller. JD 1D (1) to rear hub and secure.
-
Withdraw hub and carrier from half shaft.
-
Remove hub puller from hub and carrier and recover thread protector
-
Recover spacer from half shaft (1).
-
Examine inner oil seal track and renew if necessary.