Vanden Plas L6-4.2L (1982)
CAUTION: Seal the access panel and the hole in the shroud with a suitable sealing compound.
Fig. 24
Fit the front locknut (1, Fig. 24) to the cable but do not tighten at this stage.
Ensure that the gearbox selector and quadrant selector levers are in "1".
Adjust the front (1, Fig. 24) and rear (2, Fig. 24) locknuts until the cable can be connected to the quadrant lever without either quadrant or gearbox lever
being disturbed.
Tighten the locknuts, secure the cable with a new split pin (3, Fig. 24).
Refit the selector indicator assembly and gear knob.
Place the selector lever in "P" and replace the console.
