Vanden Plas (X300) L6-4.0L (AJ16) (1996)
/l6-4.0l_(aj16)/Page-1654003.png)
10.
Remove the Jaguar emblem and then the retaining screw of the cover plate on the center console rear extension (Illustration 2). Remove the cover
plate.
11.
Carefully pry up the front of the veneer panel on the rear extension of the center console. The veneer panel is secured by two threaded studs
located toward the rear which engage into nylon bushes held in the console rear extension (Illustration 2). The forward edge of the veneer plate is
retained underneath the leather trimmed cover plate.
12.
Remove the center console rear extension assembly from the vehicle.
13.
Install the leather trimmed switch plate (Illustration 3). The retaining screw now installs from underneath.
14.
Check the switch markings for right and left hand heaters and install them in the correct openings (Illustration 3). Press the switches fully into the
switch plate.
15.
Set the rear console extension assembly aside.
16.
Remove the two rear heel board fuse box covers.
17.
From the rear seat pan area, lift up the carpet and thread the switch connectors of the link harness through the carpet.
