Vanden Plas (X300) L6-4.0L (AJ16) (1996)
-
From below the vehicle, reposition the harness 'P' clip to its mounting stud.
-
Fit and tighten the 'P' clip securing nut.
-
Align the harness 'P' clip to transmission shift abutment bracket.
-
Fit and tighten the 'P' clip securing screw.
-
Fit and align the rotary switch protection cover; fit and torque tighten the securing bolts.
-
From inside the vehicle, fit the grommet in the correct orientation and reposition the harness in the correct position.
-
Reconnect the rotary switch harness multi-pin plugs.
-
From below the vehicle, ensure that there is no excess slack in the switch harness that could foul the propshaft.
-
Lower the vehicle on the ramp.
-
Reposition and fit the tunnel carpet.
-
Using suitable tie straps, secure the harness to the console harness.
-
Fit and fully seat the veneer panel to the console; fit and tighten the wing nuts.
-
Fit and fully seat the shift lever surround.
-
Connect the Performance Mode switch to the harness multi-pin plug and fully seat the switch.
-
Fit and align the console veneer panel rear finisher.
-
Place the ashtray assembly in position.
-
Reconnect the cigar lighter / illumination harness connectors.
-
Reposition and fit the ashtray assembly; fit and tighten the securing screws.
-
Close the armrest lid.
-
Reconnect the battery.