Vanden Plas (X308) V8-4.0L (AJ27) (2000)
Scuff Plate: Service and Repair
Scuff Plate Trim Panel
Scuff Plate Trim Panel (76.13.81)
Removal
1. NOTE: The finisher can be easily damaged, care must therefore be exercised during removal.
Using a thin plastic lever and starting at one end, carefully remove the tread plate finisher and place face uppermost on sheet of clean dry
polythene.
2. Remove tread plate securing screws and remove tread plate.
Installation
1. Ensure that draught welt is correctly positioned and fully seated on aperture flange.
2. Position sill tread plate and install three securing screws.
3. Ensure that sill contact area is clean and dry.
4. Install tread plate finisher, pressing firmly into place. If finisher has been renewed, remove protective film.