Vanden Plas (X308) V8-4.0L (AJ27) (2000)
4. Install caliper to hub carrier.
Install and tighten bolts to 60 Nm.
5. CAUTION:
^
Always install new brake pads, irrespective of the condition of the original pads, when renewing brake discs.
^
Retracting the caliper piston may cause the fluid reservoir to over-flow. Remove brake fluid spillage immediately from paint work with clean
water.
^
Note the condition of pins and replace if necessary.
Install brake pads.
Slowly retract caliper pistons.
Install pads.
Position anti-rattle spring.
Install pins - make sure pin collets are fully engaged into caliper.
6. Repeat above procedure to install opposite side brake disc.
7. Fit wheels.
8. Remove stands and lower vehicle.
9. CAUTION: Remove brake fluid spillage immediately from paint work, with clean water.