Vanden Plas (X308) V8-4.0L (AJ27) (2000)
Rain Sensor: Service and Repair
Removal
1. Remove battery cover and disconnect ground cable from battery terminal.
2. Remove cover from rear view mirror base.
3. Disconnect flying lead from sensor unit connector.
4. Using a thin plastic blade, carefully remove sensor unit from windshield.
5. Using an approved solvent, remove residual adhesive from windshield.
6. If sensor is to be re-used, remove adhesive pad and clean base of unit using an approved solvent.
Installation
1. Install new adhesive pad.
Peel backing paper from one side of new adhesive pad.
Position pad correctly in clear area of obscuration band and press firmly to fully seat.