Vanden Plas (X308) V8-4.0L SC (AJ27) (2001)
4. Secure pipe and harness to support with new tiestrap.
6. Install shock absorber and mounting bracket.
^
Position shock absorber mounting bracket on wishbone rear arm.
^
Install wishbone front arm to rear arm bolt and tighten to 77-103 Nm.
7. Tighten shock absorber lower bolt and nut to 43-57 Nm.
8. Position and partially tighten wishbone rear eccentric bolt.
^
Rotate eccentric bolt to align large graduation with mark made during removal.
^
Ensuring bolt remains in position, partially tighten nut.
9. Install stabilizer bar link to wishbone securing nut and bolt and tighten to 41-54 Nm.
10. Position vertical link/ hub assembly on lower ball joint taper pin, install nut and tighten to 60-80 Nm.