Front Cross-Member Service and Repair for Vanden Plas (X308) V8-40L SC (AJ27)
/v8-4.0l_sc_(aj27)/Page-721015.png)
12. Tighten rear mounting bolt and nut to 131-185 Nm.
^
Repeat procedure to tighten opposite side rear mounting bolt and nut.
13. Connect steering rack transducer harness front connector.
^
Connect steering harness connector.
^
Install harness connector on body retaining clip.
14. Slacken adjuster nut and remove camber tie down tool 204-114 from suspension.
^
Repeat procedure to remove tie down tool from opposite side.
15. Using screws or new scrivets, secure undertray to front bumper cover.
16. Using new tiestrap, secure undertray to crossbeam brace.
17. Using new scrivets, secure undertray to each wheelarch liner.
