Vanden Plas (X308) V8-4.0L SC (AJ27) (2001)
1. Position vertical link/ hub assembly on upper ball joint taper pin.
2. Position vertical link/ hub assembly on lower ball joint taper pin, install securing nut and tighten to 60-80 Nm.
3. Install nut securing upper ball joint to vertical link and tighten to 60-80 Nm.
4. Position tie rod ball joint taper pin on steering arm and install and tighten securing nut to 71-85 Nm.
5. Install wheel speed sensor.
^
Position wheel speed sensor on vertical link.
^
Install sensor securing bolt and tighten to 8-10 Nm.
6. Remove wire temporarily securing vertical link to road spring.
7. Install brake disc.
8. Release tension on road spring.
^
Rotate adjuster of special tool 204-111 to release spring tension.
^
Remove special tool and adaptor from spring.