X-Type (X400) V6-2.5L (2005)
Oil Temperature Sensor For ECM: Service and Repair
Oil Temperature Sensor
Removal
1. Raise and support the vehicle.
2. Remove and discard the oil filter.
3. Disconnect the oil temperature sensor electrical connector.
4. Remove the oil temperature sensor.
Installation
1. To install, reverse the removal procedure.
-
Tighten to 15 Nm.
NOTE: Apply a small bead of sealant WSK-M4G328-A3 or equivalent sealant meeting Jaguar specification on the first three threads of the oil
temperature sensor.
2. Install a new oil filter.
3. Check and top up the engine with oil.