X-Type (X400) V6-2.5L (2005)
/v6-2.5l/Page-862003.png)
Ensure the transfer case is cold before assembly.
8.
Install the new gasket over the shaft.
9.
Holding the new gasket in correct position, install new nut and toque to 20 Nm (14.7 lb-ft).
10.
Locate the stake position on the shaft and stake the nut to shaft.
11.
Install the transfer case support bracket and bolts. (Figure 1)
12.
Tighten the top two bolts to 25 Nm (18.5 lb-ft) and the bottom bolt to 47 Nm (34.5 lb-ft).
13.
Refer to GTR section (30.10.06) and install exhaust muffler inlet pipe.
Disclaimer
