jaguar Workshop Repair Guides

Jaguar Workshop Service and Repair Manuals

Campaign - Ignition Supply Fuse Change|Page 6490 > < Campaign - Ignition Supply Fuse Change|Page 6481
Page 1
background image

Fuse: All Technical Service Bulletins
Campaign - Ignition Supply Fuse Change

XT418-S918

DATE
03/02

X-TYPE

MODEL 
2002 MY X-Type

Fuse Rating Change From 30 to 15 Amp - Ignition Supply - Service Action S918

Issue:

On manual transmission X-TYPE vehicles, within the above VIN range, the ignition supply fuse located in the power distribution fuse box is over rated
and does not provide adequate protection for the circuit involved.

Action:

At the next service opportunity, replace the ignition supply fuse with a lower rated fuse on 2002 MY manual transmission X-TYPE vehicles within the
above VIN range.

PROCEDURE

1.

Open hood and fit fender protector covers.

2.

Disconnect vehicle battery.

3.

Displace and remove engine compartment fuse box cover.

4.

Displace and remove 30 amp fuse (ignition supply) from position F28 of fuse box.

5.

Install and seat 15 amp fuse to position F28 of fuse box.

6.

Install and secure engine compartment fuse box cover.

7.

Reconnect vehicle battery.

8.

Remove fender protector covers.

9.

Close hood.

Parts Information:

Warranty Information

Service Action S918

CURRENT SYSTEM

Warranty claims should be submitted quoting S918 in place of the warranty fault code along with SRO 86 92 95 and the part number for the ignition
supply fuse. This will result in a labor time allowance of 0.2 hours to replace the ignition supply fuse. Should a vehicle be brought back into the
workshop for this action alone to be undertaken, an additional labor time allowance of 0.1 hours may be claimed quoting SRO 10 10 10 for drive in/drive

Campaign - Ignition Supply Fuse Change|Page 6490 > < Campaign - Ignition Supply Fuse Change|Page 6481