X-Type (X400) V6-3.0L (2002)
/v6-3.0l/Page-1559001.png)
Hood: Adjustments
Hood Alignment (76.16.02)
1. Remove the hood latch.
2. NOTE: Right hand shown, left hand similar.
Remove the A-pillar exterior trim.
3. NOTE: Right hand shown, left hand similar.
Remove the lower A-pillar drainage channel.
4. Loosen the hood hinge screws to 3-5 Nm.
5. Pull up/push down on hood.
6. Set hood to the correct alignment.
7. Tighten the hood hinge screws to 20 Nm.
