X-Type (X400) V6-3.0L (2002)
/v6-3.0l/Page-1587011.png)
27. Cut and remove the tie straps securing the outer casing of the driveshaft universal joint.
-
Cut and remove the tie straps securing the driveshaft to the front exhaust hanger.
28. Connect the driveshaft to the transfer case.
CAUTION: INSTALLING A NEW DRIVESHAFT. If a new driveshaft is to be installed, no gasket is required between the driveshaft and the drive
pinion flange. Failure to follow this instruction may result in damage to the vehicle.
CAUTION: INSTALLING THE ORIGINAL DRIVESHAFT. If a gasket was removed from between the driveshaft and the drive pinion flange on the
driveshaft removal procedure, make sure to install a new gasket. If no gasket was removed from between the driveshaft and the drive
pinion flange on the driveshaft removal procedure, a new gasket is not required. Failure to follow this instruction may result in damage to
the vehicle.
