X-Type (X400) V6-3.0L (2002)
6.
Measure the run-out of the inside diameter of the transfer case output flange (Illustration 4).
If the inside diameter is greater than 94.076 mm or less than 94.030 mm and/or the run-out is greater than 0.12 mm, continue from step 7. If readings are
in specification continue from step 8.
7.
Install a new drive pinion seal and flange (see Global Technical Reference GTR Workshop Manual, section: 308-07, SRO 46.10.04).
If the VVA still confirms a driveshaft vibration:
8.
Install a new driveshaft (see Global Technical Reference GTR Workshop Manual, section 205-01, SRO 51.25.13).
Parts Information:
Warranty Information: