jaguar Workshop Repair Guides

Jaguar Workshop Service and Repair Manuals

Body - Sunroof Bounces Back When Closing|Page 2889 > < Sunroof / Moonroof Motor|Service and Repair
Page 1
background image

Sunroof / Moonroof Windguard: All Technical Service Bulletins
Body - Sunroof Bounces Back When Closing

NUMBER: JTB00119
(Issue 1)

DATE: 11 Sept 2008

MODEL: XF

SECTION: 501

Roof Opening Panel 'Bounces Back' When Closing - Repair Procedure

AFFECTED VEHICLE RANGE

CONDITION SUMMARY:

Situation: 

While closing the roof opening panel, the panel may bounce back at approximately two-thirds closed as it passes over the wind deflector. This failure to
close may be caused by the spring rates of the wind deflector springs being too high, which activates the anti-trap feature of the roof opening panel.

Action:

In the event of a customer concern of the above, refer to the Repair Procedure outlined below to install new roof opening panel wind deflector springs
(VIN R00019 - R22000) and carry out a roof opening panel motor synchronization procedure (VIN R00019 - R31206).

PARTS

Tools:

Refer to Workshop Manual (GTR) for any special tools required.

Warranty 

REPAIR PROCEDURE

REPLACE ROOF OPENING PANEL WIND DEFLECTOR SPRINGS (VIN R00019 - R22000)

1.

Fully open the roof opening panel.

NOTE:

Remove one Torx screw at a time as the wind deflector is under tension.

Body - Sunroof Bounces Back When Closing|Page 2889 > < Sunroof / Moonroof Motor|Service and Repair