jaguar Workshop Repair Guides

Jaguar Workshop Service and Repair Manuals

Battery - Battery Discharged|Page 160 > < Headlamp Alignment Control Module|Locations
Page 1
background image

Power Distribution Module: All Technical Service Bulletins
Battery - Battery Discharged

No: JTB00213
Issue: 1
Date: 23 NOV 2010

SECTION: 418

Battery Discharged

AFFECTED VEHICLE RANGE:

CONDITION SUMMARY:

Situation:

The vehicle battery may become discharged if the vehicle is left standing overnight or longer. This may be due to a MOST bus issue causing a
1.6Amp drain when the Infotainment Control Module (ICM) is shut down.

NOTE:

This software update should be carried out on any customer complaint of a discharged battery. The cause of the discharged battery must be
investigated as per normal processes; any other faults found must be claimed as a separate claim.

Action:

In the event of a customer concern of the above, refer to the Repair Procedure outlined below to update the ICM software.

PARTS:

No parts necessary

TOOLS:

IDS with latest IDS-DVD and Calibration File; first available on IDS-DVD123_V7.08 Calibration File 56 Jaguar-approved Midtronics Vehicle Power
Supply

Refer to Workshop Manual for any required special tools

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.
Always refer to DDW to obtain the latest repair time.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

Normal Warranty policies and procedures apply

REPAIR PROCEDURE

UPDATE INFOTAINMENT CONTROL MODULE SOFTWARE

CAUTION:

Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the vehicle.

CAUTION

A Jaguar-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during IDS diagnosis / module programming.

Battery - Battery Discharged|Page 160 > < Headlamp Alignment Control Module|Locations