jaguar Workshop Repair Guides

Jaguar Workshop Service and Repair Manuals

Cooling System - Fan Fuse Failure|Page 6014 > < Wheel Fastener|Specifications
Page 1
background image

Air Conditioning Switch: All Technical Service Bulletins
Cooling System - Fan Fuse Failure

82-44
Amended
10/95

Cooling System - Fan Fuse Failure

MODEL Sedan (4.0L) Range 1995 MY 
VIN 720001 on

DATE 7/95

Remove and destroy Bulletin 82-44 Dated 7/95.
Replace with this Bulletin.
Diagnostic information has been added.

ISSUE:

The cooling fan circuit protection fuses F11 (30 Amp) and F17 (30 Amp) located in the LH Engine Bay Fuse Box may fail intermittently on 1995 MY
XJ6 and XJR vehicles. The problem may be caused by a defective single pressure switch which controls slow fan speed operation.

During normal operation, the single pressure switch closes after refrigerant pressure rises to 12 bar. The fans are switched in series, which results in slow
speed operation. If refrigerant pressure rises to 22 bar, the triple pressure switch closes. The fans are then switched in parallel, which results in high
speed operation.

If the single pressure switch is defective, and refrigerant pressure rises enough to close the triple pressure switch, the fans will switch directly to high
speed mode from off. This results in a higher current draw than the normal sequence of switching from low to high speed. The higher current draw may
blow either or both fuses F11 and F17.

The fuses supply power as follows:

F11

30 Amp Both cooling fans in series operation;
right side cooling fan in parallel operation.

F17

30 Amp Left side cooling fan in parallel operation.

ACTION:

If the cooling fan circuit fuse(s) fail, check the cooling fan operation as follows:

1.

If the engine is hot, disconnect the radiator thermostatic switch.

2.

Replace fuses F11 and F17 as needed.

Cooling System - Fan Fuse Failure|Page 6014 > < Wheel Fastener|Specifications