XJ-12 (X300) V12-6.0L (1995)
Shift Solenoid: Service and Repair
'A' SHIFT SOLENOID, RENEW
-
Open the hood and fit a suitable fender cover.
-
Raise the vehicle on a ramp.
-
Drain the transmission lubrication system.
-
Remove the fluid pan.
-
Disconnect the internal harness plug from the 'A' Shift solenoid.
-
Release and remove the 'A' Shift solenoid to valve body securing screw.
-
Remove the solenoid from the valve body (Fig. 1).
-
Remove and discard the '0' ring seal from the valve body.
-
Place the solenoid aside.
-
Fit a new '0' ring seal to a new 'A' Shift solenoid.
-
Lubricate the '0' ring seal.
-
Fit the solenoid to the valve body using a twisting motion.
-
Fit and tighten the solenoid to the valve body using a new securing screw.
-
Connect the internal harness plug to the solenoid.
-
Refit the fluid pan.
-
Lower the vehicle on the ramp.
-
Refill the transmission unit with fluid.
-
Remove the fender cover and close the hood.
'B' SHIFT SOLENOID, RENEW