XJ-12 (X300) V12-6.0L (1995)
Camshaft Position Sensor: Service and Repair
Remove
-
Open the hood and fit a wing cover.
-
Open the trunk and remove the battery cover.
-
Disconnect the battery earth lead.
-
Disconnect the camshaft position sensor harness multiplug.
-
Undo and remove the camshaft position sensor securing bolt.
-
Remove the camshaft position sensor and discard the "0" ring seal.
Refit
-
Fitting a new camshaft position sensor is the reverse of the removal procedure.
-
Always use a new O-ring seal and lubricate before fitting.