XJ-12 (X300) V12-6.0L (1995)
/v12-6.0l/Page-1184001.png)
Band Apply Servo: Service and Repair
Rear Servo Assembly
Rear Servo Assembly, Renew
^
Raise hood and fit fender cover.
^
Raise the vehicle on a ramp.
^
Drain the transmission lubrication system.
^
Remove the fluid pan.
^
Remove the fluid filter.
^
Remove the transmission internal harness.
^
Remove the internal lubrication pipe.
^
Remove the manual detent spring assembly.
^
Remove the internal dipstick stop.
^
Remove the valve body and accumulator assembly; check the condition of the gasket.
^
Release and remove rear servo cover securing bolts and remove rear servo cover.
^
Remove rear servo gasket and discard.
^
Remove rear servo piston assembly (Fig. 1) and place aside.
^
Clean relevant parts and faces and inspect all seals for condition.
