XJ-12 (X300) V12-6.0L (1995)
Fluid - A/T: Service and Repair
Fluid Pan, Renew
FLUID PAN, RENEW
-
Open the hood and fit a suitable fender cover.
-
Raise the vehicle on a ramp.
-
Slacken the underfloor catalyst to downpipe clamps securing bolts.
-
Displace and reposition the olive clamps on the pipes.
-
Slacken the underfloor catalyst to intermediate silencer clamps securing bolts.
-
Displace the underfloor catalyst assembly rearwards to disconnect from the downpipes.
-
Displace and remove the olives from the downpipes.
-
Using a wire brush, clean the olives and downpipe joints.
-
Place a suitable piece of wood between the underfloor catalyst and the body for access.
-
Drain the transmission lubrication system.
-
Release and remove the fluid pan securing bolts.
-
Drain the residual fluid from the fluid pan.
-
Remove the fluid pan (1 Fig. 1) and gasket (2 Fig. 1).
-
Clean the fluid pan gasket, which can be re-used if in good condition.
-
Place the fluid pan gasket aside.
-
Remove the magnet (3 Fig. 1) from the fluid pan.
-
Clean the magnet and place on a clean surface.
-
Clean the transmission fluid pan joint face.
-
Clean the fluid pan.
-
Place the fluid pan aside.
-
Attach the magnet to the recess in a new fluid pan.
-
Fit and align a serviceable gasket to the fluid pan.