XJ-12 (X300) V12-6.0L (1995)
15.
Raise the jack, compressing the spring, until the bracket and spacers completely contact the vehicle body, ensuring that the peg is centered in the
bush. Install the retaining nuts and washers.
16.
Remove the jack and lower the vehicle.
17.
Remove the engine support MS53.
18.
Raise the vehicle and install the rebound washer and the center mounting bolt (Illustration 2).
19.
Install the underfloor catalytic converter section of the exhaust system.
20.
Lower the vehicle, reconnect the battery negative cable, and reset the clock.